So after lookin through all the CODE 2 entree's I was sorta inspired to try to come up with a yoyo. Just a heads up I know very little about what is best for a high end yoyo's this was basically just a learning experience and I dont expect this to be anything amazing. I think the axle is a bit big and I am not sure what effect having the overhang on the outside of the cup would cause if any but it looks slick to me. Any feedback/advice would be awesome

Two things,

1. What's up with the bearing seat. It looks a little funky...
2. That overhang is nearly impossible to cut on a lathe, no matter how good you are.

I got a little carried away with the bearing seat I will work on it make it a bit more orthodox.

Will scrap the overhang

To much center weight as well. It is dead weight. Makes it unstable.